Connect socket scanner with f.e iPad

• Turn on the scanner device.
• Scan barcode to set scanner into iOS mode
  
  
  
  
• Activate Bluetooth on Apple device.
• Scanner device will be listed in ”My devices” as ”Socket [xxxxxx]”.
• Select device to connect to.
  It will then be shown with status connected
  

• Now the scanner is ready to be used with Bitlog WMS.

Remove an already paired scanner unit

• Turn on the scanner device.
• Push down the scanner button and hold it down.
• Push down the on button and hold it down.
• The scanner will make 3 beeps and then you can let go of the buttons.
• The units are un-connected, and the scanner will be turned off. 
• Next time the scanner device is turned on it will be able to connect to new devices.

Reset the scanner to factory settings with code

• Scan barcode 

Reset the scanner to factory settings manually 

• Turn on the scanner device.
• Push down and keep down the scanner button.
• Push down and keep down the on button.
• After 15 sec there will be 1 beep, let go of the scanner button
• The scanner will beep 5 times and then turned off. 

______________________________________________________________________________________________

If you experience any problems or have more questions that you can't find the answer to, 

please contact our support at [email protected]